Peerless-av GC-UNV - Installation Manual do Utilizador descarregar pdf (Página 11)

Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112 or 708-865-8870.

11 of 13

ISSUED: 01-28-11 SHEET #:125-9176-1

Figure. 4.1

Figure. 4.2 Figure. 4.3

BOTTOM OF MOUNTING SURFACE

TOP OF MOUNTING SURFACE

Mounting Surface Lock down Installation

Place wall plate (B) onto mounting surface as a template. Level, and mark the center of two rectangular mounting

holes. Drill two 5/16” (8 mm) dia. holes through mounting surface. Secure using two carriage bolts (R) through wall

plate (B) and mounting surface as shown in gure 4.1.

Hand tighten slope nut (S) through 1/4-20 x 1 3/4" carriage bolt (R) until snug against bottom of desktop surface as

shown in gure 4.2.

Thread another slope nut (S) upside-down, about two turns from rst slope nut (S). Insert a open box wrench

between both slope nuts (S) and tighten. NOTE: Avoid jamming both slope nuts (S) together, doing so may make it

difcult to remove slope nut used for tightening rst slope nut (S) as shown in gure 4.3.

After slope nut is secure remove bottom slope nut and add plastic cap (T) as shown in gure 4.4.

Repeat with remaining 1/4-20 x 1 3/4" carriage bolt (R).

Figure. 4.4

TIGHTENING

SLOPE NUT

1 2 ... 6 7 8 9 10 11 12 13

Sem comentários

Peerless-av GC-UNV - Installation Manual do Utilizador Página 11