Peerless-av GC-UNV - Installation Manual do Utilizador descarregar pdf (Página 10)

Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112 or 708-865-8870.

10 of 13

ISSUED: 01-28-11 SHEET #:125-9176-1

SOLID CONCRETE

CINDER BLOCK

1/4"

Installation to Solid Concrete or Cinder Block

• When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" (35 mm) of actual con-

crete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid

part of the block, generally 1" (25 mm) minimum from the side of the block. Cinder block must meet ASTM C-90 specica-

tions. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill to avoid

breaking out the back of the hole when entering a void or cavity.

• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.

• Make sure that the wall will safely support four times the combined load of the equipment and all attached hardware and

components.

WARNING

CUTAWAY VIEW

INCORRECT CORRECT

wall

plate

wall

plate

plaster/

dry wall

plaster/

dry wall

concrete

Drill holes and insert anchors (P).

Place plate (B) over anchors (P) and secure with screws (O).

Tighten all fasteners.

concrete

surface

• Tighten screws so that wall plate is rmly attached,

but do not overtighten. Overtightening can damage

screws, greatly reducing their holding power.

• Never tighten in excess of 80 in. • lb (9 N.M.).

• Always attach concrete expansion anchors directly

to load-bearing concrete.

• Never attach concrete expansion anchors to

concrete covered with plaster, drywall, or other

nishing material. If mounting to concrete surfaces

covered with a nishing surface is unavoidable,

the nishing surface must be counterbored as

shown below. Be sure concrete anchors do not

pull away from concrete when tightening screws. If

plaster/drywall is thicker than 5/8" (16 mm), custom

fasteners must be supplied by installer.

WARNING

Place wall plate (B) on wall as a template. Level, and mark the center of the three mounting holes. Drill three 5/16"

(8 mm) dia. holes to a minimum depth of 2.5" (64 mm). Insert anchors (P) in holes ush with wall as shown. Fasten

two #14 x 2.5" wood screws (O) leaving 1/4" of thread exposed as shown in Figure 4.3.

Hook wall plate (B) onto exposed #14 x 2.5" wood screws (O). Secure using one #14 x 2.5" wood screws (O) as

shown in gure 4.4. Skip to Step 5.

Figure. 4.3

Figure. 4.4

SOLID CONCRETE

CINDER BLOCK

1 2 ... 5 6 7 8 9 10 11 12 13

Comentários a estes Manuais

Sem comentários

Peerless-av GC-UNV - Installation Manual do Utilizador Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Peerless-av GC-UNV - Installation